AKAB-IR
Stock:
In Stock
30.00 Lt.
Passive infrared detector AKAB-IR, Italy The AKAB-IR is a high quality passive infrared volumetric detector. The technology implemented, the optimisation of the calibration, the interchangeability of the lens, the thoroughness of the details and the forefront design makes the AKAB-IR the passive infrared detector that synthesize the most actual installation requirement.
SYSTEM INSTALLATION Select the best possible location in the room. If possible, aim the unit towards the room’s interior and away from windows, moving machinery, heating and cooling sources. WALL MOUNTING The maximum range is obtained at mounting height of 2,10 Mt., Vertical Adjust in A position (fig 10); It’s possible to mount the detector at a height up to 4 Mt (fig 6-7). Make sure that the sensor has a clear line of sight to all areas you wish to protect. Remove the front cover, loosen the screw and remove the circuit board. Engrave, as need, the keyholes on the back cover (fig 1), knock out the Wall Tamper keyhole if required (IMQ II°Liv.) cut out the wire keyhole. Sign the holes on the wall having care to sign the hole Wall Tamper at the centre of the keyhole. Make the fixing hole (6mm) on the wall. Fix the screw Wall tamper at the wall leaving the screw head out of 5/6 mm. Run the cable through the wire keyhole. FEATURES - Digital simpling of the signal
- 4 mode of detection
- Alarm memory with delay
- Low consumption
- Solid state relay
- Vertical adjust
- Interactive Led OFF
- Range selection presettet
- PIR double element
- Sealed optics
- Interchageable lens
- Fresnel lens (standard) 18 zones on 4planes with look down zone
- Wall tamper
- Corner, wall or bracket mounting
- Bracket (option) antiviolation with regulation 90° horizz. 60° vert. Akab-ir_manual (1).pdf
- Warranty: 12 months
|
+370 67198111
Security systems
